Tools
Cattools configuration for Cisco Firepower 1150 Security Appliance - FTD device
This article provides information about the device configuration for Cisco Firepower 1150 Security Appliance - FTD. The device should be configured properly in order to complete the backup of the device on Cattools.
First published date
3/14/2022 4:50 PM
Last published date
10/12/2022 3:41 PM
Overview
When running a device backup of the Cisco Firepower 1150 Security Appliance - FTD, the backup appears to be running fine but the backup appears to be cut off at the same spot in the backup file. The file does not look like a complete backup. This article provides the configuration so that the backup file is complete. This configuration is verified on Cattools version 3.12.1.
Product section
Kiwi CatTools
Resolution
Device Info:
Device Type: Cisco.Firewall.ASA
Model: Other
Method: SSH2
Set up the device with the following configuration in the Variations:
Prompts Tab:
VTY Prompt: DeviceHostname>
Enable Prompt: DeviceHostname#
More/PagingPrompt section
Remove checkmark from ‘Paging prompt’ and ‘Paging key-stroke’
Full Prompts Tab:
Removed checkmarks from ‘Full Hostname’ ‘Full VTY Prompt’ and ‘Full Enable Prompt’
Additional Commands Tab:
Checkmark in Enter Enable Mode > entered ‘enable’ in text box
Unchecked Exit Enable Mode
Checkmark in Show Running Config > entered ‘show run’ in text box
Pre/Post Login tab:
Checkmark in Post-login keys > entered ‘system support diagnostic-cli’ in text box
Device Type: Cisco.Firewall.ASA
Model: Other
Method: SSH2
Set up the device with the following configuration in the Variations:
Prompts Tab:
VTY Prompt: DeviceHostname>
Enable Prompt: DeviceHostname#
More/PagingPrompt section
Remove checkmark from ‘Paging prompt’ and ‘Paging key-stroke’
Full Prompts Tab:
Removed checkmarks from ‘Full Hostname’ ‘Full VTY Prompt’ and ‘Full Enable Prompt’
Additional Commands Tab:
Checkmark in Enter Enable Mode > entered ‘enable’ in text box
Unchecked Exit Enable Mode
Checkmark in Show Running Config > entered ‘show run’ in text box
Pre/Post Login tab:
Checkmark in Post-login keys > entered ‘system support diagnostic-cli’ in text box