Submit a ticketCall us

Systems Monitoring for Dummies
Our new eBook will teach you the fundamentals and help you create monitors and alerts that are effective, meaningful, and actionable. Monitoring is more than a checkbox on your to-do list. This free eBook will give you practical advice to help you succeed in all aspects of monitoring – discovery, alerting, remediation, and troubleshooting. Don’t miss out on this indispensable resource for newbies, experienced IT pros, and everyone in between. Register Now.

Home > Success Center > User Device Tracker (UDT) > UDT Administrator Guide > Troubleshooting > Node discovery fails for some devices

Node discovery fails for some devices

Table of contents
Created by Steven Bansil_ret, last modified by Steven Bansil_ret on Feb 02, 2017

Views: 15 Votes: 0 Revisions: 2


The device discovery fails when it's done for specific devices.


  • UDT Discovery runs on the poller the nodes are affiliated with (i.e. it respects main and additional polling engines) since UDT 2.5. Make sure the machine where appropriate poller is installed has access to the selected device.
  • Run UDT Compatibility Checker (discovery target ) from machine with the right polling engine against the device and check the results.
  • Increase Port/Layer3 Discovery Job Timeout (Advanced Settings page)
  • Increase SNMP Timeout (Advanced Settings page)
Last modified