Submit a ticketCall us

WebinarWebinar: A checklist for planning your Network Performance Monitor (NPM) upgrade

Are you ready for your next upgrade? To help you plan smoothly, join this webcast to learn more about, SolarWinds® Orion® Installer, SolarWinds Upgrade Advisor, Upgrades Guides, Training Videos, and other resources available. We’ll share key upgrade planning considerations, lessons learned from customers with practical advice from SolarWinds Product Experts. We’ll also give practical tips to identify the estimated time needed and resources, how to prepare the business and IT staff for changes, ways to plan for required system changes, and more.

Register now.

Home > Success Center > Orion Platform > Orion Documentation > Orion Platform Administrator Guide > Monitor SNMP traps

Monitor SNMP traps

Table of contents
Created by Caroline Juszczak, last modified by Magdalena.Markova on Nov 30, 2016

Views: 1,984 Votes: 0 Revisions: 11

This Orion Platform topic applies only to the following products:

ACMIPAMNAMNCMNAMNOMNTASAMSRMVNQM

If you monitor a large number of devices, where each device may have many connected objects of its own, requesting information from each device is impractical. You can set up the SNMP Trap Server, and each managed device can notify it about any issues by sending a trap message.

You can monitor SNMP traps with SolarWinds NPM or SolarWinds SAM.

SNMP traps are received by the SolarWinds Trap Service, which listens for incoming trap messages on UDP port 162, and then decodes, displays, and stores the messages in the SolarWinds Orion database.

The SolarWinds Trap Service can receive and process SNMP traps from any type of monitored network device, and can handle large numbers of simultaneously incoming traps.

A SolarWinds installation can process approximately 500 traps per second. Higher capacity can only be achieved with significant hardware improvements over minimum SolarWinds requirements.

You can view SNMP traps either in the Orion Web Console or in the Trap Viewer application. The Trap Viewer application allows you to configure trap-specific alerts, to view, filter, and search for traps.

Before you begin

  • Configure devices to send SNMP traps to the IP address assigned to the Orion server. For more information about proper configuration, refer to the documentation supplied by the vendor of your devices.
  • Make sure the UDP port 162 is open for IPv4 and IPv6.
  • When you use SNMPv3 for polling a device and receiving traps from it, confirm that the same authentication type (auth, noauth, or priv) is configured for both polling and traps.
Learn more:

See the list of Trap alert variables you can use.

Last modified

Tags

Classifications

Public