Hide this message
Looking to compare latest NPM features with previous versions of NPM?
The NPM new feature summary offers a comparison of new features and improvements offered with this release.
To be able to view clients in a wireless heat map, you must add at least three access points and one signal sample, or four access points into the map.
Viewing the location of connected clients is supported only for Cisco access points with CleanAir technology.
You should now be able to see clients connected to access points available on the map.
If you cannot see a client on the map, its position might be calculated outside of the selected map. To verify this, consult the Displaying item in the legend. If the map shows less clients than are actually connected, such as one out of three, it means that the remaining clients are either outside of the map, or filtered out.
Too many clients on the map might make the map crowded, and could also cause performance issues. A wireless heat map can show a maximum of 100 clients.
Random selection of all clients
Clients connected to an AP
Select which clients to show