Submit a ticketCall us

Announcing NPM 12.2
With NPM 12.2 you can monitor your Cisco ASA firewalls, to monitor VPN tunnels for basic visibility and troubleshooting tunnels. NPM 12.2 also uses the SolarWinds Orion Installer so you can easily install and upgrade one or more Orion Platform products simultaneously.
See new features and improvements.

Home > Success Center > Network Configuration Manager (NCM) > VLANs are not displayed in the Config Change Template

VLANs are not displayed in the Config Change Template

Created by Bill Corgey, last modified by Melanie Boyd on Apr 13, 2017

Views: 74 Votes: 0 Revisions: 4

Overview

When a Config Change Template for operations against a VLAN are run, the VLANs are not being presented so they can be selected.

 

Environment

  • NCM 6.1 and later

 

Cause 

 

This occurs because the inventory for interfaces have not been run, the extended VLANs option is not selected, or the devices are not responding to SNMP queries for the IF-MIB when the inventory is run.

 

Resolution

  1. Open the Orion Web Console and click Settings > NCM settings > Node Inventory.
  2. Select the Standard section Interfaces and Bridge Tables.
  3. At the bottom of the page, select Extend VLANs inventory.
  4. Click Submit.


Once an inventory is run on all the desired nodes, the VLAN options should be populated. 

If a job is scheduled for inventory, ensure the Interfaces and Bridge Tables are selected for that job too.

 

Note: The information presented will only be current as of the last inventory run. SolarWinds suggests running a job routinely and before any job where inventory data is used in the Config Change template or before any job where commands issued based on this data are used.

 

 

 

 

Last modified
13:45, 13 Apr 2017

Tags

Classifications

Public