Submit a ticketCall us

Announcing NPM 12.2
With NPM 12.2 you can monitor your Cisco ASA firewalls, to monitor VPN tunnels for basic visibility and troubleshooting tunnels. NPM 12.2 also uses the SolarWinds Orion Installer so you can easily install and upgrade one or more Orion Platform products simultaneously.
See new features and improvements.

Home > Success Center > Network Configuration Manager (NCM) > Managing SNMP v1 NETOPIA Routers Using NCM Fails Due to FIPS Compliance

Managing SNMP v1 NETOPIA Routers Using NCM Fails Due to FIPS Compliance

Table of contents
No headers
Created by Interspire Import, last modified by MindTouch on Jun 23, 2016

Views: 12 Votes: 0 Revisions: 13

For users that are required to run Orion in FIPS mode:

Devices such as older NETOPIA devices, may be unable to communicate with Orion/NCM.  This due to the fact that these older devices only have SNMPv1 and Telnet/SSH1 protocols available to them.

This issue only arises when running Orion/NCM in FIPS mode, FIPS disables both SNMPv1 and SSHv1 protocols: 

  • All programs that use Network Security Services (NSS) have a FIPS Mode according to the FIPS compliance regulations of US Government.
  • FIPS is not enabled by default with Orion/NCM, this is something that has to be enabled in some restricted environments
  • NETOPIA routers support only SSH1 and/or telnet for command line sessions over tcp/ip.


Note: The issue is likely to occur on any devices that do not support SSH2, not just netopia devices. 

Refer to information about FIPS - What is FIPS 140-2?

Applies to: NCM 7.x

Last modified
21:09, 22 Jun 2016

Tags

Classifications

Public