Submit a ticketCall us

WebinarWebinar: A checklist for planning your Network Performance Monitor (NPM) upgrade

Are you ready for your next upgrade? To help you plan smoothly, join this webcast to learn more about, SolarWinds® Orion® Installer, SolarWinds Upgrade Advisor, Upgrades Guides, Training Videos, and other resources available. We’ll share key upgrade planning considerations, lessons learned from customers with practical advice from SolarWinds Product Experts. We’ll also give practical tips to identify the estimated time needed and resources, how to prepare the business and IT staff for changes, ways to plan for required system changes, and more.

Register now.

Home > Success Center > Netflow Traffic Analyzer (NTA) > NTA - Knowledgebase Articles > Cisco 2900 series routers sample configuration for NTA

Cisco 2900 series routers sample configuration for NTA

Table of contents
Created by Sterling Elliott, last modified by MindTouch on Jun 23, 2016

Views: 3,125 Votes: 1 Revisions: 4

Updated June 13, 2016


This article provides an example NTA configuration for Cisco 2900 series routers.

\Note: SolarWinds does not provide support for device configuration. It is recommended that you open a case with the device vendor.


All NTA versions


Configure terminal

router-2960(config)#interface FastEthernet 0/1

Note: The layer 3 interfaces. Configure on all interfaces interested in collecting Netflow data.

router-2960(config-if)#ip route-cache flow or ip flow ingress


router-2960(config)#ip flow-export destination x.x.x.x 2055 ( port used to export flow

Note: x.x.x.x is the Orion Server IP Address and 2055 is the collection port on the NPM server. You can verify the port by going to Setting > NTA Settings; Scroll down to the NetFlow Collector Services and look under COLLECTIONS PORT(S).

router-2960(config)#ip flow-export source FastEthernet 0/1

Note: This should be the interface that is configured with the IP address that the device is being monitored in Orion by.

router-2960(config)#ip flow-export version 5

router-2960(config)#ip flow-cache timeout active 1
router-2960(config)#ip flow-cache timeout inactive 15

Note: The two commands above will ensure that you are not receiving any data peaks that exceed the bandwidth of the circuit.

router-2960(config)#snmp-server ifindex persist


router#write mem

How to verify data is being exported:
router#show ip flow export
router#show ip cache flow 


Last modified