Submit a ticketCall us

ebook60.pngHow to be a Cisco® ASA ace

Our eBook, Thou Shalt Not Pass…I Think?! can help you overcome the challenges of monitoring and managing Cisco ASA firewalls. This eBook is a great read if you’ve been frustrated with monitoring firewalls, managing ACL configs, and troubleshooting VPN connections.

Get your free eBook.

Home > Success Center > Kiwi CatTools > Kiwi CatTools Documentation > Kiwi CatTools 3.11 Administrator Guide > Introduction to Kiwi CatTools > Using CatTools on a VM

Using CatTools on a VM

Table of contents
No headers
Created by Caroline Juszczak, last modified by Caroline Juszczak on Jun 28, 2016

Views: 540 Votes: 0 Revisions: 1

CatTools will run on VM systems but you may need to adjust the setup of the VM in certain circumstances.


Setting the number of processors

You can configure VM's to use multiple 'virtual' CPU's, (based on the number of physical CPU's you have on your server). However, because CatTools spawns multiple clients this can actually slow down the operation of CatTools while the VM waits for physical processors to become simultaneously free. For best results you should therefore ensure that there is only 1 virtual CPU configured for for your VM.

Last modified