Submit a ticketCall us

Announcing NPM 12.2
With NPM 12.2 you can monitor your Cisco ASA firewalls, to monitor VPN tunnels for basic visibility and troubleshooting tunnels. NPM 12.2 also uses the SolarWinds Orion Installer so you can easily install and upgrade one or more Orion Platform products simultaneously.
See new features and improvements.

Home > Success Center > Kiwi CatTools > Add a Device in Cattools for Gigamon device

Add a Device in Cattools for Gigamon device

Table of contents
Created by Chris Foley, last modified by MindTouch on Jun 23, 2016

Views: 41 Votes: 1 Revisions: 5


This article provides information and steps to configure Kiwi CatTools to backup a Gigamon device, when it does not exist as a device type in CatTools. 


  • CatTools version 3.6 and later
  • All Windows versions


1. Add a new Device to CatTools and set the Device Type to Generic.Device. 

2. Enter the settings on the Device Information and Password fields. 

3. Go to Variations tab, and then click Use Variations.

4. On the Full Prompts tab, set the following fields:

Full Enable prompt - {device name} #

Full Config prompt - {device name} >

Note: The device name appears in the prompt when you are logged into the Gigamon device. 


5. Go to the Additional Commands tab and set the Disable Paging field to term len 999.

6. Click Save, and then click OK. 

7. Add a new Device.Backup.Running config  activity and assign the new Device to this activity.



Last modified
19:43, 22 Jun 2016