Submit a ticketCall us

WebinarUpcoming Webinar: How Help Desk and Remote Support Pays for Itself

Learn how help desk software can simplify ticketing management, allow you to track hardware and software assets, and accelerate the speed of IT support and service delivery. Gain insights on how remote support tools allow your IT team to maximize their efficiency and ticket resolution by expediting desktop troubleshooting, ultimately helping keep end-users happy and productive.

Register here.

Home > Success Center > Archive > 2018April16 - Deletes > Failover Engine (FoE) > Create a Static Route for the SolarWinds Channel Connection in a WAN Environment

Create a Static Route for the SolarWinds Channel Connection in a WAN Environment

Table of contents
This article is slated for Deletion. Do not update this article. If you have questions please send a message to

Created by Michael Perez, last modified by MindTouch on Jun 23, 2016

Views: 892 Votes: 1 Revisions: 5


This article provides information on how to set up static routing between Orion Failover Engine servers deployed on a WAN. When configured for WAN deployment, the SolarWinds Channel IP addresses at the remote (disaster recovery) site are in a different subnet than those in a LAN and therefore require persistent static routes to maintain continuous communications between servers independent from traffic on the principal network. SolarWinds recommends against implementing routing that uses Interface IDs (appears as a number starting with 0x on aroute print result), because an interface id is dynamic and can change when a server is restarted or a NIC is disabled and re-enabled.

Note: Microsoft Windows supports only one gateway per server.


All FoE versions ​


It is necessary to create a static route using the destination (channel of other server), a locked down mask of with a default gateway for the channel subnet (this means that only the channel NIC can contact the other channel IP and nothing else). In order for the static routes to be implemented, use the following procedure on both servers.


Note: Before starting this procedure, verify that the Routing and Remote Access Service (RRAS) is started and set to Automatic on all servers.

  1. From Administrative Tools, select Routing and Remote Access, and select the server name.
  2. From the Action menu, select Configure and Enable Routing and Remote AccessThe configuration wizard starts.
  3. Select Custom Configuration and LAN routing. Verify that the RRAS service is started.
  4. Select the server, and go to IP Routing, and select Static Routes.
  5. From the Action menu, select New Static Route.
  6. Select the channel NIC, enter the remote channel IP address followed by the subnet mask and the default gateway for the channel subnet.
  7. Repeat Steps 1 through 6 to configure a static route from the remote host to the local host.

Test the channel routing from both sides using the following command to ensure that all packets are sent through the channel IP and not the primary IP:

pathping -n Channel_IP


On Windows Server 2008 with the IIS Service Installed


On Windows Server 2008, the Routing and Remote Access Service (RRAS) is dependent on the HTTP service. When the IIS service is installed on an Orion Failover Engine server group, the plug-in will stop the HTTP service on the secondary server. This causes the Routing and Remote Access (RRAS) service to stop and results in dropping the channel.

To resolve this issue, use the ROUTE ADD command from the command line as shown below:

1. Click Start Run, type CMD, and click OK to open a command prompt window.

2. From the command prompt type:

ROUTE ADD [DestinationIPAddress] MASK [netmask] [Gateway]

METRIC [metric] IF [Interface] -p

For example:


METRIC 3 IF 2 -p

3.  Close the command prompt window.


For further information, contact SolarWinds Support.



Last modified



Internal Use Only